Section 3: Troubleshooting - Teknik SMARTBAY One Box User Manual

RF GROUPING
Short press "Learn/Erase" button on RC to activate pairing mode, and the
receiver unit will flash once every second for 3min.
Note: the unit can only pair up to 30 units.
Short press "Transmit" button on RC, the commander unit (master unit) will
flash one time to send the transmission signal.
Upon receiving the transmission signal, the receiver unit (slave unit) will
rapidly flash 3 times in 1s to indicate the success of pairing. Repeat this step
to pair more units. One more short press on "Learn/Erase" button to the
receiver unit to complete the pairing process, the receiver unit will quit the
pairing mode.
Note:
Press button RX100%, the light on receiver unit is 100% on upon receiving
RF on signal; Press "RX STBY%" button, the light(s) goes to preset stand-by
dimming level directly.`
Erase:
Long press "Learn/Erase" button for 3s to the sensor unit. The
rapidly flash for about 5s. all commands it has received before will be erased.

SECTION 3: TROUBLESHOOTING

MALFUNCTION CAUSE REMEDY
The fixture does not light up
The fixture is always on
The fixture is on when it should not
NOTES
1.
Minimum distance from luminaire to any flammable object is 2m.
2.
In case of weight discrepancy when replacing old lamps, please ensure that the mounting structure is rated to
withstand the weight of the new lamp and installation materials.
3.
For further information, please contact Teknik (www.tekniklighting.com.au) or your local distributors.
red LED indicator
CAUSE
Incorrect daylight threshold setting
Faulty fixture
No power supply
Continous movement in the detection zone
Sudden change in temperature due to weather (wind,
rain, snow) or air expelled from fans, or open window s
Red LED indicator is on for 3min
The receiver unit (slave unit)
The red LED indicator flash one time.
The commander unit (master unit)
The red LED indicator flash rapidly
when RF signal is received
The receiver unit (slave unit)
Red LED indicatoron in on
The receiver unit (slave unit)
Adjust daylight threshold setting
Replace fixture
Check power to sensor
Check detection area setting
Adjust zone, change installation site
Short press "Learn
/Erase" button
Short press "Transmit"
button
Short press "Transmit"
button
REMEDY