External Connections - Hitachi EC702HP Operation Manual

Section 3 - Installation (ATSC EC702HP Transmitter)

3.8.2.2 External Connections

The following external connections must be made:
- AC power feeding
- Grounding / Interlock
- Rigid line / Filter / Antenna
- Transport Stream IN
A- AC Power Feeding

Pass the AC power feeding cables through the hole at the rack bottom and connect them to
INPUT connector of the MCCB module.
B- Grounding / Interlock

Insert the grounding cable through the hole and connect it to the GROUND connector of the
MCCB module.
INPUT CONNECTOR
Manual Rev. 0.0 - April 2016
Rear partial view of the transmitter
The screws must be properly tightened in order to avoid sparks.
GROUND CONNECTOR
AC CABLES
Figure 3-56
ATTENTION
3-42