Table of Contents
Advertisement
Section 3 - Installation (ATSC EC702HP Transmitter)
3- Insert and fasten the MCCB drawer.
4- Insert and fasten the rejection loads drawer.
5- Insert and fasten the other power drawers in the rack in the following sequence P2
i.e. from bottom up.
6- Insert and fasten the Ethernet* switch (optional).
7- Insert and fasten the digital exciter B (optional).
8- Insert and fasten the digital exciter A.
9- Check the presence and physical integrity of all the drawers' power feeding and communication
points.
1
P2: Power Amplifier 02
*Ethernet is a trademark of the Xerox Corporation.
Manual Rev. 0.0 - April 2016
Figure 3-44
Side view of the transmitter - Insertion of drawers
1
and P1,
EXCITER A (MOD GV 40153)
EXCITER B (MOD GV 40153)
ETHERNET SWITCH
POWER AMPLIFIER 01
(MOD GV 40001)
POWER AMPLIFIER 02
(MOD GV 40001)
REJECTION LOADS
DRAWER
(MOD GV 40041)
MCCB DRAWER
MOD GV 40031
3-34
Advertisement
Table of Contents
