Ebyte E95-DTU User Manual page 5

Chengdu Ebyte Electronic Technology Co.,Ltd
④
Start two serial port debugging assistants, select the serial port baud rate to be 9600bps (default), and the check method to
be 8N1 to make serial port transparent transmission;
⑤
If the customer needs to switch the working mode, it can be controlled by the Mode button to switch between different
working modes (M0 indicator, M1 indicator). Press and hold the Mode button for about 1 S and then release it to switch
modes. The mode switching details are shown in the table below:
No.
Type
Transparent
Mode 0 Transmission
Mode
Mode 1 WOR Mode
Configuration
Mode 2
Mode
Deep Sleep
Mode 3
Mode

Note: The DTU has a power-down save mode function (the factory default setting is transparent transmission mode),
the user needs to switch the corresponding mode according to the M1 and M0 indicators (effective immediately).
Copyright ©2012–2020, Chengdu Ebyte Electronic Technology Co.,Ltd
M1 M0
Light Light Serial port open, wireless open, transparent transmission (factory
Off Off default mode), support special command air configuration
Light Light
Can be defined as WOR sender and WOR receiver, support air wakeup
Off On
The user accesses the register through the serial port to control the
Light Light
working status of the DTU. The user can configure the DTU through
On Off
the computer configuration software.
Light Light
DTU goes to sleep mode
On On
E95-DTU(400SL22-485) User Manual
Description
5