Set Up The System - KVH Industries TracPhone V30 Installation Manual

Set Up the System

Set Up the System
Follow the steps on the next few pages to access the
setup wizard and configure system for use.
Access the Setup Wizard
Follow the steps for either option below to access the
VSAT-Hub's setup wizard.
Option 1: Using the Wireless Connection
1. Select the KVHVSAT-<last 3 digits of VSAT-Hub
serial no.> network from your mobile device's Wi-Fi
settings to connect to the VSAT-Hub.
2. Enter the default password: <full 9-digit VSAT-Hub
serial no.>.
3. Start the web browser and enter
https://kvhonboard.com.
Note: If the setup wizard is not displayed, try entering
http://192.168.5.1, which is the default IP address of the
VSAT-Hub.
Figure 27: Wi-Fi Connection
Option 2: Using the Ethernet Connection
1. Connect a laptop PC configured for DHCP directly to
any "Ethernet" port on the VSAT-Hub.
2. Start the web browser and enter
https://kvhonboard.com.
3. Enter the default password: <full 9-digit VSAT-Hub
serial no.>.
Note: If the setup wizard is not displayed, try entering
http://192.168.5.1, which is the default IP address of the
VSAT-Hub.
Figure 28: Wired Ethernet Connection
TracPhone V30 Installation Guide
19