Table of Contents
Advertisement
4.4 Verify Device Functionality and Test Network Coverage
Check LEDs
1.
The LED should be solid white. If it is flashing orange, the firmware is automatically upgrading and the
LED should turn green when the upgrade is completed (normally in under thirty minutes).
Note: Your MR46E-HW must have an active route to the Internet to check and upgrade its firmware.
Verify access point connectivity
2.
Use any 802.11 client device to connect to the MR46E-HW and verify proper connectivity using the
client's web browser.
Check network coverage
3.
Confirm that you have good signal strength throughout your coverage area. You can use the signal
strength meter on a laptop, smart phone, or other wireless device.
Troubleshooting
5
Reference the Meraki knowledge base at
http://meraki.com/support/knowledge_base
for additional
Hide quick links:
Advertisement
Table of Contents
