Table of Contents
Advertisement
4.4 Verify Device Functionality and Test Network Coverage
1. Check LEDs
The LED should be solid white. If it is flashing orange, the firmware is automatically upgrading
and the LED should turn green when the upgrade is completed (normally in under thirty
minutes).
Note: Your MR55-HW must have an active route to the Internet to check and upgrade its firmware.
2. Verify access point connectivity
Use any 802.11 client device to connect to the MR55-HW and verify proper connectivity using the client's
web browser.
3. Check network coverage
Confirm that you have good signal strength throughout your coverage area. You can use the signal
strength meter on a laptop, smart phone, or other wireless device.
Troubleshooting
5
Reference the Meraki knowledge base at
information and troubleshooting tips.
Regulatory
6
FCC Compliance Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
This de- vice may not cause harmful interference, and (2) this device must accept any interference received,
including interference
that may cause undesired operation.
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residen-
tial
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution
Any changes or modifications no expressly approved by Meraki could void the user's authority to operate this
equipment. This Transmitter must not be co-located or operation in conjunction with any other antenna or
transmitter.
FCC Radiation Exposure Statement
23
http://meraki.com/support/knowledge_base
for additional
Advertisement
Table of Contents
