Especificaciones - Ricatech RMC150 User Manual

ESPAÑOL
ADVERTENCIA:
PARA EVITAR RIESGO DE INCENDIO O DE DESCARGAS
ELÉCTRICAS, NO EXPONGA ESTE APARATO A LLUVIA O HUMEDAD.
NO QUITE LA CUBIERTA. LOS PILOTOS LUMINOSOS ESTÁN
SOLDADOS EN SU LUGAR. NO HAY PIEZAS ÚTILES EN SU
INTERIOR. EN CASO DE REPARACIONES, ACUDA SIEMPRE A
PERSONAL DE REPARACIONES CUALIFICADO.
ADVERTENCIA
RIESGO DE DESCARGAS
ELÉCTRICAS. NO ABRIR
ADVERTENCIA: PAPR REDUCIR
El símbolo del relámpago
con punta de flecha dentro
EL RIESGO DE DESCARGAS
de un triángulo equilátero
ELÉCTRICAS, NO RETIRE LA
pretende advertir al usuario
CUBIERTA (NI LA PARTE
de la presencia de "voltaje
peligroso" sin aislar dentro
TRASERA) NO HAYPIEZAS QUE
del producto. que puede
PUEDA USAR EN SU INTERIOR.
tener la suficiente magnitud
EN CASO DE REP ARACIONES
como para suponer un riesgo
ACUDA SIEMPRE AL SERVICIO
de electrocución para las
personas.
TÉCNICO.

Especificaciones

Rango de frecuencias : MW 522 - 1620 KHz
: FM 87.5 - 108 MHz
Puerto USB 2.0 : VelocidadÊmáxima 512MB -4GB
(Soporta FAT16, FAT32)
Consumo de energía : 18W
Antenas : Cable de antena externo para FM
: Antena de ferrita incorporada para AM
Corriente eléctrica : AC 230V ~ 50Hz
Tamaño del altavoz : 2 x 3" de tipo dinámico
Ohmios del altavoz : 4 ohm
Vatios del altavoz : 5W
Salida de corriente : 2W x 2
*DISEÑO Y ESPECIFICACIONES SUJETOS A CAMBIOS SIN PRECIO AVISO.
El signo de exclamación
dentro de un triángulo
equilátero pretemde advertir
al usuario de la presencia
de instrucciones de
funcionamiento
(reparaciones) importantes
en el manual que acompaña
el aparato.
46
ENGLISH
TROUBLESHOOTING
The re is no p owe r
1. Make sure radio is plugged in correctly.
2. Look at the STAND BY INDICATOR (3) and check to see if it is red.
3. If the red light is on, press the POWER button (12/29) to turn the unit on.
The re is no s ound
1. Make sure the mute function is turned off.
2. Check that the volume is turned up by pressing VOLUME UP button (56) on the remote.
Note: Volume range on some units start at level 15 and ends at level 40.
3. Make sure INT./EXT. switch (18) on back of radio is switched to INT. (Unless you are using external speakers, in which case it
should be on EXT. )
4. Check to make sure power is turned on.
CD d oe s not p la y
1. Check to make sure CD is inserted correctly (label side facing up).
2. Check to see that surface of CD is clean.
3. Make sure function switch is set to CD mode.
USB - The re is no mus ic p la ying whe n PLAY/PAUSE (USB) is p re s s e d .
1. Make sure the MP3 device/Flash Drive has stored music files.
2. The unit will only play Flash Drives up to 512 – 4096 Bytes
3. Reset USB by switching the unit Off or switching to another Mode.
4. Check if the file(s) is WMA file(s). The unit does not play WMA format, only MP3 format.
Re mote not working
1. Replace batteries.
2. Be sure to point the remote towards remote sensor when operating.
3. Remove obstacles in the path of the remote and radio so the remote signal has a straight path to the radio.
Turnta ble will not work
1. Check it the AC Power source is connected.
2. Press the POWER button (12/29) (on front of unit or on RC) to turn the unit on, the STAND BY INDICATOR (3) light should be
off.
3. Check that the unit is in PHONO Mode. Try moving the Tone Arm (26) to the right until a click is heard.
No Sound is c oming from the unit
1. The white protective needle cover has not been removed
2. The Volume is not turned up
The Tone Arm will not move
1. The black tie-wrap has not been removed from underneath Tone Arm (26).
2. Tone Arm hold down clip has not been released
Trademarks – MPEG Layer-3 audio coding technology licensed from Fraunhofer IIS and Thomson
11