Table of Contents
Advertisement
there occurs when the output system for full color display and the corresponding font,
otherwise the system display as shown in the figure.
3) Each axis of the right side of the pulse shows that the selected axis in the shaking hand wheel
sent after the number of pulses, select one axis and then press the return to zero, zero after the
end of the re press the return to zero key to calculate the number of pulses corresponding to the
single circle.
4) The lower right corner of the file can through the button "multiple" to switch, divided into low,
medium and high speed, with hand wheel control transmit pulse rate.
Press the Cancel button to exit the interface.
（6） Key detection screen
After entering the Figure 3.1 press the 4 button to enter the detection screen as shown in Figure
3.9：
Test the function of each button on this interface，Long press "
this interface.
3.3 Program instructions and sample instructions
3.3.1 Instruction definition and description
1）S Directive: speed command.
Instruction format ：
Line
instruction
number
line
S
number
xx
M
Figure 3.9
Start X
End X
Wire
feeding
X Speed
Y Speed
X Start X
End Feed
24
TH08HA-Spring Machine System
ADT-
" the blank key that will exit
Speed
probe
ratio
line Ratio
cylinder
Advertisement
Table of Contents
