Adjusting The Working Angle; Switching On And Off (With Telescopic Arm); Working With The Telescopic Arm; Trouble Shooting - Grizzly AGS 108 Lion Original Instructions For Use

GB

Adjusting the working angle

For a comfortable edge cut, the equip-
ment holder (20) of the telescopic arm can
be rotated to the right or left.
Set the desired position by pulling
the release switch (23) and rotat-
ing the equipment holder (20) of
the telescopic arm. The equipment
holder locks into the desired posi-
tion when the release switch is
released.
Switching on and off
(with telescopic arm)
1. Remove the blade guard
( 12/15) before switching the
device on.

Trouble shooting

Problem
Device doesn't
start
Bad cutting
results
82
Possible Cause
Equipment is not charged
Switch lock ( 2) has not
been operated properly
On/off switch (
be defective
Too much friction due to
lack of lubrication
Dirty blade ( 10/13)
Blade ( 10/13) is blunt
or has nicks
Blade ( 10/13) is dam-
aged
2. To switch on, hold the switch
3. To turn it off, release the on/off
Working with the telescopic
arm
• Slowly push the device on the wheels
over the floor. By doing so, you will
achieve an even cutting height.
Error correction
Charge equipment (see „Charging pro-
cess")
Switch on (see „Operation")
8) may
Repair by Service Centre
Lubricate blade (
(see „Cleaning/Maintenance")
Clean blade
(see „Cleaning/Maintenance")
Sharpen blade (see „Cleaning/Mainte-
nance") or replace (see „Spare parts/
Accessories")
Replace blade
(see „Spare parts/Accessories")
lock (24) on the handle of the
telescopic arm and simultane-
ously press the on/off switch
(25). Release the switch lock,
device runs at top speed.
switch (25).
10/13)