Garrison 043-5494-2 Instruction Manual page 12

22.1 ~ 38.6
Window stool
Window stool
Foam seal
INSTALLATION INSTRUCTIONS
Installation in a double-hung sash
window
Foam seal A
(adhesive type)
1. Cut the foam seal A (adhesive type) to the proper length and
attach it to the window stool. (Fig. 8). Then cut the foam seal B
to the proper length and place it on the above foam seal A.
(Fig. 9)
Fig. 8
2. Attach the window slider kit to the foam seal B. Adjust the
length of the window slider kit according to the width of
window, shorten the adjustable window kit if the width of
window is less than 22.1 inches.
Window kit
Open the window sash and place the window slider kit on
Foam seal B
the foam seal B. (Fig. 9)
3. Cut the foam seal (adhesive type) to the proper length and
attach it on the top of the window kit. Shown as in Fig. 10
Fig. 9
4. Close the window sash securely against the window.
5. Cut the foam seal to an appropriate length and seal the
Window kit
open gap between the top window sash and outer window
Foam seal B
sash. Shown as in Fig. 11.
Fig.10
Fig.11
.
10