Asus RP-AX56 Quick Start Manual

Quick
Start Guide
RP-AX56
Dual-Band Wireless Repeater
BEFORE SETUP
01
Placing your RP-AX56
Plug your RP-AX56 into a power outlet near
1
your router/AP.
SETUP METHODS
If you would like to connect RP-AX56 to other WiFi networks excluding AiMesh-supported routers, please download the
ASUS Extender App.
Download the ASUS
1
METHOD
Extender App
WE SUGGEST...
Check the LEDs and see the LED explanations.
2
around
2 meters
Set up RP-AX56 as a repeater
Hardware Explanations
1
Plug RP-AX56 into a power outlet.
The LED will start breathing white for 3 seconds while booting
2
up.
Button Explanations
LED
WPS button
reset button
WPS BUTTON
Launch the WPS Wizard.
RESET BUTTON
Reset the system to its factory default settings.
LAN PORT
Connect your PC to the LAN port with a network cable.
3 Wait for the LED to flash and turn solid blue,
indicating that your RP-AX56 is ready to connect
to your existing router/AP.
Connect via WPS
2
METHOD
1
Press the WPS button on your router/
AP.
LED Explanations
Repeater Mode
Status
Booting up
Booting up complete (haven't
connected to Router)
Reset (use a pin to press the
reset button for 5 seconds)
Rescue mode
Starting WPS
Connected to the router with
Good Signal
Conneccted to the router with
Weak Signal
No Signal
AP mode (with wired
connection)
AP mode (without wired
connection)
LAN port
AiMesh Mode
Status
Booting up
Booting up complete (not
connected to AiMesh Router)
Reset (use a pin to press the
reset button for 5 seconds)
Rescue mode
Connecting to the AiMesh Router Blinking Blue
Connected to the AiMesh Router
with Good Signal
Connected to the AiMesh Router
with Weak Signal
No Signal
Ethernet backhaul
2
Press the WPS button on your
RP-AX56 for more than two (2)
seconds until the LED starts to
blink blue.
LED Behavior
Blinking White
Solid Blue
Blinking Yellow
Solid Purple
Blinking Blue
Solid White
Solid Yellow
Solid Red
Solid White
Solid Red
LED Behavior
Blinking White
Solid Blue
Blinking Yellow
Solid Purple
Solid White
Solid Yellow
Solid Red
Solid White