Aiphone BA-1P Instructions

The BA-1P Paging Adaptor allows paging to external speakers from the AP-M or MP-S series
master stations. For each zone of paging, use a BA-1P with the appropriate sized amplifier.
The BA-1P provides outgoing paging only. Talkback is not available.
WIRING DIAGRAM:
AP-5M
1
2
3
4
5
E
SPECIFICATIONS:
Power Source: Supplied by master
Input: 8 ohms
Output: 10K ohms
Amplifier input
requirements: Aux input (10K ohms)
Dimensions: 4-1/8"H x 2-1/2"W x 1-1/2"D
Aiphone Communication Systems
1700 130th Ave. N.E.
Bellevue, WA 98005
(425) 455-0510
FAX (425) 455-0071
BA-1P
Paging Adaptor
AP-M or MP-S Series Systems
- INSTRUCTIONS -
BA-1P
Org
OUTPUT
Brn
TONE
Yel
INPUT
Grn
TONE: Control to adjust the
NOTES:
1. The above example shows station 5 accessing the paging
zone. Any unused station can be used for a paging zone.
2. The colored wires at each end of the BA-1P are the Input
and Output. Connect them to the intercom and amplifier as
shown.
3. Only wiring concerning the BA-1P is shown here. For
complete installation information see the system's
instruction manual.
4. The TONE control is located on the top of the BA-1P, and
requires a screwdriver for adjustment.
TOLL FREE TECHNICAL SUPPORT:
(800) 692-0200
TOLL FREE FAX LINE:
(800) 832-3765
E-MAIL: tech-serv@aiphone.com
Use with:
Amplifier
HOT
GND
paging volume
BA-1P COLOR CODE DEFINITIONS:
Org:
Brn:
Yel:
Grn:
TO PAGING
OUTPUT
SPEAKERS
Hot side of output
(Connect to amplifier input)
Ground side of output
(Connect to amplifier input)
Hot side of BA-1 input
(Connect to station # on master)
Ground side of input
(Connect to "E" terminal on master)
Special
Order
Products
BA-1P Instr.
0598bkjd