Advertisement
Quick Links
Advertisement
Related Manuals for DFRobot BEETLE KIT0059
Summary of Contents for DFRobot BEETLE KIT0059
- Page 1 BEETLE Workshop Kit quick start guide...
-
Page 2: Getting Around
getting around Cover... - Page 3 getting around COMPONENT AMOUNT Beetle Beetle Shield Micro USB Cable SPEC DETAIL Microcontroller ATmega32u4 Clock Speed 16MHz Operating Voltage 5V DC Digital I/O Analog Input SPEC DETAIL Power Interface Flash Memory 32 KB (4 KB by bootloader) SRAM 2.5 KB EEPROM 1 KB...
-
Page 4: Getting Connected
getting connected You can directly stack the Beetle onto the Beetle Shield in this kit when using. Some soldering will be needed for reinforcement. Tip: Check carefully when stacking the Beetle and the Beetle Shield together, turn to corresponding pins between two boards, then press from upon till no room left. - Page 5 getting connected IO Port Mapping with Arduino SILKSCREEN DIGITAL ANALOG UART Serial 1 Power Interface SILKSCREEN DESCRIPTION —...
- Page 6 precautions • This product uses DC power supply with a working voltage of 5V. 6V and over will damage the product permanently. This product works reliably between 4.5V-5V; it may work under 3V-4.5V, but the reliability is not guaranteed. • For large load applications (such as motor control), you need to connect the loaded VCC and GND directly with power supply, and parallel with capacitor over 10uF, in order to prevent restart or malfunction caused by large...
- Page 7 For support questions, troubleshooting, or help with your Beetle Workshop Kit, please contact DFRobot Tech Support. online: www.dfrobot.com/forum email: techsupport@dfrobot.com telephone: +86 21 61620183 facebook: dfrobot twitter: dfrobotcn...
Need help?
Do you have a question about the BEETLE KIT0059 and is the answer not in the manual?
Questions and answers