Page 6
4
Installing the iGurt
To install the iGurt on the fi xed end of the lashing strap,
complete the steps described in the following section.
No tools are necessary for the installation.
[1]
Operate the locking springs on the right-side of
the iGurt by pushing with your fi nger to unlock the
locking bolt.
[2]
While holding the locking springs down, press out
the locking bolt by around 5 mm. Now, you can let
go of the locking springs. Pull the locking bolt out
completely.
[3]
Put the locking bolt aside and lift the iGurt up.
Picture 3
Picture 4
Picture 5
BPW-BA-iGurt 37842001e