Setup - Agnpro EP-15AV User Manual

Setup

1. Remove the dust-proof plastic sheet
Remove the dust-proof plastic sheet from the surface of monitor.
2. Connect your monitor to the video source
Composite Video Input - Connect your monitor to a video source
such as Digital Video Recorder, Multiplexer, Camera, VCR, etc using
a cable with an RCA jack. To use BNC connectors, you will need to
use a composite to BNC adaptor. For some models, this adaptor is
included with the monitor.
VGA Input - Connect your monitor to your computer or other device
using the D-Sub 15-pin connector. With the computer switched off,
connect the analog VGA signal cable to the "ANALOG" port on the
back of the monitor. The monitor is compatible with IBM PC and
MacIntosh computers.
3. Press the Power switch (3) to turn on your monitor. You should
see the picture on your monitor now. If not, please check the
Troubleshooting" section of this user manual for details.
8