Camera Install Guide
This device can be installed using the following references. For any alternative installation please
contact the manufacturer for safety recommendations.
Caution: We strongly recommend use of anti-slip gloves when handling the unit
Installing cable gland (NPT 3/4"-14) at Cable Entry (Ex Type)
Important:
To install this device, you must follow following instructions.
1.
The cable gland (1) is passed through the cable (2).
Note:
If the cable's connector is difficult to pass due to the sealing rubber of the cable gland, disassemble the
cable gland and insert it onto the cable.
2.
Assembling cable gland (1) to the cable entry (3).
Note:
Teflon thread seal tape recommended to apply thread of cable gland
Important: A certified cable gland must be used.
Copyright © 2019 OPTICOM INTERNATIONAL INC., All Rights Reserved. Ver 1.1
CC03-IP2MZ30-E Operation Manual
ss
series User's Manual
.
10