Honeywell GENT Xenex Operating Instructions And Log Book page 6

Fire Panels
Indications given of various conditions
Visual
Zone Fire (1-8) - Red
Fire Common
Disabled - Yellow
Test - Yellow
Power - Green
Access / Function - Yellow
Audible
Buzzer
Sounder circuits
Signal Aux Relay contacts Normally de-energised
Out
Common fault -
Common fire- Normally deactive
Fault Conditions
In the event of an automatic fault detection the indications given are:
q Common Fault light is lit and may be accompanied with other fault indicators
q buzzer sounds intermittent, (except for system fault which is a continuous sound).
To Cancel the fault buzzer
a)
#Enter the 3 digit code
# Coded entry is only required if Cancel Buzzer function is configured for operation at Access level 2.
b) b) After investigating fault, press the Cancel Buzzer
indications remain active.
The fault indications are normally automatically extinguished once the fault condition has been rectified.
Action to rectify fault
NOTE: All fault rectification work must be done by suitably qualified personnel.
q The fault indicators may be extinguished during a fire condition.
q The mains failure condition overrides all other fault indications in order to preserve battery standby capacity.
NOTE: A comprehensive fault finding guide is included in the Data Installation and Commissioning guide.
4188-424 issue 8_Part 2_07-14_Xenex
-
Red
Normally active
n n n
to gain access to the controls.
Indications given of various conditions
CONDITIONS
Normal Fire
ON
ON
ON ON
ON
ON
normal C/O
active active
de active active
C/O - Change Over
button. Notice the buzzer is silenced but other
6
New fire Access
(different level 2, 3
zone) or 4
ON
ON
ON ON
ON
ON
ON
C/O normal
active active
active de active
Function
key
pressed
ON
Fast pulse
normal
active
de active