Advertisement
Quick Links
45.00
CONTROLLER
Read handbook before use
!
Not for use in hazardous areas
Check supply voltage
I
O
Blackbody
Source
Description
This blackbody source is particularly suitable for
the calibration of thermal imagers.
It comprises a heat / cool ridged blackbody
source of 70mm diameter whose temperature
can be set from 20°C to 45°C to a resolution of
0.1°C.
Features
Combined stability / accuracy of ±0.2°C using
contact thermometry.
Emissivity is better than 0.97 ± 0.02.
Evaluation at Land Pyrometers showed the
advantages of fitting a stainless steel tube
around the plate to give better uniformity and
less sensitivity to draughts and ambient
temperature effects.
TH
ISSUE 2, 18 MARCH 2020
Blackbody
Source
Advertisement
Related Manuals for Isotech 988
Summary of Contents for Isotech 988
- Page 1 Blackbody Source 45.00 CONTROLLER Read handbook before use Not for use in hazardous areas Check supply voltage Blackbody Source Description This blackbody source is particularly suitable for the calibration of thermal imagers. It comprises a heat / cool ridged blackbody source of 70mm diameter whose temperature can be set from 20°C to 45°C to a resolution of 0.1°C.
- Page 2 No user Serviceable parts, do not dismantle. Width 225mm Not for use in Hazardous Areas. Depth 115mm Disconnecting device: The 988 Blackbody can be Weight isolated by removing the power cable. Accessories Switch Mode Power Supply Supplied as Standard How to Order...
- Page 3 Failure to follow these instructions could result in fatal injury or cause damage to the product. There are no user serviceable parts inside. Isotech products are intended for use by technically Contact your nearest Isotech agent for repair. trained and competent personnel familiar with good measurement practices.
- Page 4 MAY INVALIDATE THIS GUARANTEE. excluded from the apparatus. EN61010 pollution degree 2. RECOMMENDATION Environmental Ratings The life of your ISOTECH Instrument will be prolonged if it is kept clean and free from general Operating Temperature 5 - 35°C dust and debris.
Need help?
Do you have a question about the 988 and is the answer not in the manual?
Questions and answers