Table of Contents
Advertisement
4 Power Connector and LEDs
4 Power Connector and LEDs
4.1
Power Connector
The RST terminal can be used to reset the VisionBox during operation. While the signal is pulled
to GND, the VisionBox is held in reset state. Leaving the signal floating is the default mode for
normal operation.
Mating external plug component: Phoenix Contact MC 1,5/4-STF-3,5 (order no. 1847071)
4.2
System LEDs
The VisionBox has four main system LEDs. These LEDs are dual color (bicolor) types. The behavior
of LEDs A, B and C can be controlled by software.
LED
On
Figure 2: Power connector with system LEDs
Pin
1
24 V power supply
2
Reset input
3
GND
4
Shield / housing connection
Table 2: Power connector
Color
Green
Green blinking
Orange
Red
Green
A
Red
Green
B
Red
Green
C
Red
Table 3: LED values
IMAGO Technologies GmbH
Strassheimer Str. 45; 61169 Friedberg - Germany; Tel. +49 6031-6842611
info@imago-technologies.com;
Function
Function (green)
Power on
USB recovery mode
System reset or power down
FPGA configuration error
User LED 0
User LED 1
User LED 2
User LED 3
User LED 4
User LED 5
www.imago-technologies.com
Page 11 / 22
Advertisement
Table of Contents
