802.11A Transmit Script - Lantronix xPico 200 Series Certification Firmware Instructions

802.11a Transmit Script

Similar to the 802.11g script above, change the chanspec line to set the channel using the
parameter after the -c parameter and change the nrate line to set the bit rate.
The txant parameter sets the antenna to either antenna 0 or antenna 1.
xPico ® 200 Certification Firmware Instructions
wl down
wl country ALL
wl band a
wl chanspec -c 100 -b 5 -w 20 -s 0
wl mpc 0
wl ampdu 1
wl bi 65000
wl frameburst 1
wl rateset 54b
wl up
wl txant 0
wl antdiv 0
wl nrate -r 54
wl phy_watchdog 0
wl disassoc
wl phy_forcecal 1
wl phy_activecal
wl txpwr1 -1
wl pkteng_start 00:90:4c:aa:bb:cc tx 20 1024 0
11