How Does It Work - Switrace I-PLUG pdf Multi-use User Manual

How does it work?
How to START it?
When you are ready to use I-PLUG pdf Multi-use Logger, press and hold the START
button. The 4 LEDs will light sequentially, release only when the GREEN LED only is
lighted. If the device failed to start the 4 LEDs blink together, in this case repeat the
operation.
Once started, the GREEN LED will blink every 2 seconds, for the first 30 minutes.
NOTE: on older devices the GREEN LED remained lighted during the first 2 minutes, without
blinking.
After this phase, if you want to read the device status press briefly any of the two buttons (see
the section Understanding the LEDs indicators).
Start Delay
As a factory setting, I-PLUG pdf Multi-use will start recording 30 min after pressing the
START button.
How to STOP it?
I-PLUG pdf Multi-use is programmed with a typical trip duration, and will keep recording
until the end of this trip duration
There are two different ways to STOP the device before the end of the trip duration:
- Press the STOP button during 6 seconds till the 4 LED's flash – release only when the
RED LED is active and fixed.
- Connect the device on the USB port of the computer
Once stopped, pressing any button will briefly activate The RED LED as an indication that
the device has finished recording.
Configuring I-PLUG pdf Multi-use
I-PLUG pdf Multi-use data logger comes already configured to standard formats according to
your purchase.
The standard trip duration is 90 days.
Nevertheless if you wish to change the configuration like
• Changing the recording time
• Temperature scale (C°/F°)
• Adding alarms
• Changing start delay
• Entering text in the device memory
Fev, 2017 I-Plug multi-use pdf
I-PLUG Multiuse pdf
Page 2 of 10