The default password is “default”. The password is the same as is used to access the WatchDog. Therefore, if the user has changed the password, the setup password will be whatever they have changed it to. If the user forgets his/her password, see the user manual for resetting the password. PNEG-1720 Vision WatchDog Network Setup...
Page 5
IP address, reset the power ON the modem/router and then the WatchDog board. If these addresses need to be modified, click the “Configure” button to the right. This will take you to Figure Figure 1C Network Configuration PNEG-1720 Vision WatchDog Network Setup...
Page 6
After the timer expires, you will be redirected back to the Network Status screen on Page 5. If the page does not display the addresses correctly, make sure the red LED on the WatchDog board is ON and then refresh the web page. PNEG-1720 Vision WatchDog Network Setup...
MAC address of the WatchDog board can be found on a label on the front of it. Once the IP address has been setup for the MAC address, forward incoming request on ports 22, 23 and 80 to the board. PNEG-1720 Vision WatchDog Network Setup...
GSI Group, LLC Limited Warranty The GSI Group, LLC (“GSI”) warrants products which it manufactures to be free of defects in materials and workmanship under normal usage and conditions for a period of 12 months after sale to the original end-user or if a foreign sale, 14 months from arrival at port of discharge, whichever is earlier.
Need help?
Do you have a question about the Vision WatchDog and is the answer not in the manual?
Questions and answers