Table of Contents
Advertisement
Tanks (Not available with all MG3000 packages)
The Tanks data source is where the source of the information that is received from a particular
tank will display. The MG3000 speedometer can display information from an analog (US
240-33, EU 10-180 Fuel Senders), or digital sources (Bus Data). To make changes to the
tank's data source enter the DATA SOURCES menu (page 7) then:
1)
Use the UP and/or DOWN buttons to select TANKS.
2)
Press and hold the MODE button to enter the selection.
3)
Use the UP or DOWN buttons to select the T# BALLAST # to apply changes.
4)
Press and hold the MODE button to enter the selection.
5)
Use the UP or DOWN buttons to select TANK SOURCE.
6)
Press and hold the MODE button to save the new selection. The LCD screen displays,
SETTING SAVED!, and the MG3000 issues an audible beep.
Note: If an Analog source is picked you will be prompted to choose which pin the analog signal
is used by the speedometer. Select the connector pin, which the analog input is attached. See
the Wiring Diagram on page 3 for available pinpoints. If no Analog connections are available,
check with your dealer. This function may not be supported.
7)
Repeat for all tanks.
Depth
The Depth data source picks where the MG3000 system gets the information for Depth. There
are two selections Analog or Bus Data. Analog uses the analog depth transducer attached to
the back of the MG3000 speedometer for depth and Bus Data uses the information on the
CAN bus network for depth information. To make changes to the depth data source enter the
DATA SOURCES menu (page 7) then:
1)
Use the UP and/or DOWN buttons to select DEPTH.
2)
Press and hold the MODE button to enter the selection.
3)
Use the UP or DOWN buttons to select where to get Depth information.
4)
Press and hold the MODE button to save the new selection. The LCD screen displays,
SETTING SAVED!, and the MG3000 issues an audible beep.
Depth Warnings
Use the Depth Warnings edit menu to set the alarms for the depth when moving into Shallow
and Deep waters and set the Keel offset for the transducer. Follow the steps below to view the
DEPTH WARN edit menu options.
1)
From the NORMAL mode, press the MODE button once.
2)
Use the UP and/or DOWN buttons to select DEPTH WARN.
3)
Press and hold the MODE button to make the selection.
Shallow Depth Warning
Use the Shallow Warn edit menu to set the shallow water depth alarms for the MG3000
system. To make changes to the shallow water depth alarm enter the DEPTH WARN menu
(page 8) then:
1)
Use the UP and/or DOWN buttons to select SHALLOW WTR.
2)
Press and hold the MODE button to make the selection.
8
DATA SOURCES
TANKS
DEPTH
TANK SOURCE
T1: BALLAST1
T2: BALLAST2
T3: BALLAST3
TANK 1 SOURCE
US 240-33
EU 10-180
BUS DATA - 0
DATA SOURCES
DEPTH
TANKS
DEPTH
ANALOG
BUS DATA
DEPTH WARN
DISPLAY
SYSTEM
Advertisement
Table of Contents
