Table of Contents
Advertisement
4)
Press and hold the MODE button to save the setting. The LCD screen displays
SETTING SAVED! and the MG3000 issues an audible beep.
Performing A Master Reset
The Master Reset feature is used to reset the speedometer to the factory default settings.
To perform a Master Reset, enter the SYSTEM menu (page 5) then:
1)
Use the UP or DOWN buttons to select MASTER RESET.
2)
Press and hold the MODE button to enter the selection.
3)
When prompted to, PERFORM MASTER RSET?, use the UP or DOWN buttons to
select YES or NO.
If NO is selected the gauge will exit to the SYSTEM menu. If YES is selected continue with the
next step.
A warning message will display for five seconds while beeping three times which is then
replaced with "CONTINUE WITH MASTER RSET?".
4)
Use the UP or DOWN buttons to select YES or NO.
5)
Press and hold the MODE button to enter the selection.
If NO is selected, the gauge will exit to the SYSTEM menu.
If YES is selected, the MG3000 speedometer will be reset to factory default settings.
Software Version
The Software feature is used to show the current version of software that is operating in the
speedometer. This is particularly useful information when communicating with technical
support.
To view the current Software version enter the SYSTEM menu (page 5) then:
1)
Use the UP or DOWN buttons to select SOFTWARE.
2)
Press and HOLD the MODE button to enter the selection.
The display will show
• the program identifier (starts with PGF followed by three numbers),
• the revision for the program identifier
• the release date for the software
Data Sources
Use DATA SOURCES to set where the MG3000 system gets the information it needs to display
the information in the LCD. There are two data points that can be set by the Data Sources
menu, Tanks and Depth. Please see below for a further discussion for each.
Refer to your manufacturers Gauge Installation Guide of installation instructions for input
values. To enter the DATA SOURCES menu:
1)
From the NORMAL mode, press the MODE button once.
2)
Use the UP and/or DOWN buttons to select EDIT MENU.
3)
Press and hold the MODE button to enter the selection.
4)
Use the UP or DOWN buttons to select DATA SOURCES.
5)
Press and hold the MODE button to enter the selection.
7
SYSTEM INFO
MASTER RESET
SOFTWARE
INITIALIZE
MASTER RSET?
CONTINUE WITH
MASTER RSET?
NO
YES
SYSTEM INFO
SOFTWARE
INITIALIZE
AUDIO
SOFTWARE
PGFXXX
VER: X##
05/14/2012
DATA SOURCES
DEPTH WARN
DISPLAY
Advertisement
Table of Contents
