heightec RescuePack WK32 Quick Start Manual

WK32 - RescuePack
TM
This equipment should only be used by Competent Persons, who have been trained in the use of this specific kit.
These Prompt Sheets are to be read in conjunction with user instructions for each item of the kit.
Lowering
1. Select an unquestionably sound anchorage structure,
above casualty.
2. Pass anchor strop (A) around anchorage and connect
karabiner to screwlink.
3. Fit open hook to end of pole. With control device half-
threaded, extend pole to casualty (B). Attach hook to
harness and pull to release, ensuring hook gate closes
fully.
4. Pull rope to casualty tight by pulling tail end through
device (C).
5. Fully thread control-device & lock-off by passing tail
rope loop through the screwlink then around device
(D).
6. Check all connections, then cut casualty's fall arrest
lanyard, with shears.
7. Remove the 'lock-off' and gently lower casualty by
holding tail rope and squeezing device handle into
'sweet spot' (E).
The heightec Group Ltd, Lake District Business Park, Mint Bridge Road, Kendal, Cumbria, LA9 6NH, UK
REF: UI WK32 Issued: 04/02/2021
Prompt Sheet
c
A
B
D E
Revised: 04/02/2021 Approved: SBE
WK32 - RescuePack
TM
This equipment should only be used by competent persons, who have been trained in the use of this specific kit.
These user instructions are to be read in conjunction with user instructions for each item of the kit.
Raising
1. Select an unquestionably sound anchorage structure,
above casualty.
2. Pass anchor strop (A)
around anchorage and connect
karabiner to screwlink.
3. Fit open hook to end of pole. With control device half-
threaded, extend pole to casualty (B). Attach hook to
harness and pull to release, ensuring hook gate closes
fully.
4. Pull rope to casualty tight by pulling tail end through
device (C).
5. Attach hauling-device to casualty rope as shown (D).
DO NOT PUT DEVICE OVER EDGE
6. To raise casualty, pull tail rope (E).
7. When hauling-device reaches control-device, slide
hauling-device back down rope.
8. Repeat steps 6 & 7 to incrementally raise casualty as
required.
The heightec Group Ltd, Lake District Business Park, Mint Bridge Road, Kendal, Cumbria, LA9 6NH, UK
REF: UI WK32 Issued: 04/02/2021
Prompt Sheet
c
A B
D
E
Revised: 04/02/2021 Approved: SBE