de Gier I-DE User Manual page 24

3 Operation
3.5.3 Adjusting the I-DE current range (Main menu 3)
The current range of the I-DE is adjustable, with the user able to choose between a range of 0-20 mA and 4-20
mA. To do this, follow the steps below.
NOTE: The step-by-step plan below assumes that the I-DE is currently in "main menu 1" (see Figure 7).
If the I-DE is in "Normal operation" or "Error mode", "Main menu 1" can be accessed by pushing and holding the
button for two seconds.
Adjust I-DE current range
The I-DE is in "Main menu 1".
Push and hold the button for less than one second. This LED pattern will be displayed. The I-DE is in
"Main menu 2"
Push and hold the button for less than one second. This LED pattern will be displayed. The I-DE is in
"Main menu 3"
Push and hold the button for two seconds, then release. After 2 seconds, this LED pattern will be
displayed.
The I-DE is now in "Submenu 3A". (If "4 - 20 mA" has been selected).
Or, the I-DE is now in "Submenu 3B". (If "0 - 20 mA" has been selected)
Push and hold the button for less than one second to change the selection (submenu); the LED
pattern (see above) will change.
Push and hold the button for two seconds, then release. After 2 seconds, this LED pattern will be
displayed.
The selection has been saved and the appropriate current will be output.
The I-DE is in "Main menu 3"
De Gier B.V., Westlandseweg 9, 2291 PG WATERINGEN, THE NETHERLANDS,
+31 174 292089, sales@degierdrivesystems.com, www.degierdrivesystems.com
Versie 1 – 07/01/2021
24