de Gier I-DE User Manual page 17

3 Operation
3.5.5 I-DE A/B/Z mode configuration (Main menu 5)
The I-DE permits users to configure the way in which the A/B/Z outputs are controlled. Users can select either HTL, TTL or
Open Collector. To do this, follow the steps below.
NOTE: The step-by-step plan below assumes that the I-DE is currently in «main menu 1» (see Figure 7).
If the I-DE is in «Normal operation» or «Error mode», «Main menu 1» can be accessed by pushing and holding the button for
two seconds.
I-DE A/B/Z mode configuration
The I-DE is in "Main menu 1".
Push and hold the button for less than one second. This LED pattern will be displayed. The I-DE is in
"Main menu 2"
Push and hold the button for less than one second. This LED pattern will be displayed. The I-DE is in
"Main menu 3"
Push and hold the button for less than one second. This LED pattern will be displayed. The I-DE is in
"Main menu 4"
Push and hold the button for less than one second. This LED pattern will be displayed. The I-DE is in
Push and hold the button for two seconds, then release. After 2 seconds, this LED pattern will be
displayed.
The I-DE is now in "Submenu 5A". (If "Open Collector" has been selected).
Or, the I-DE is now in "Submenu 5B". (If "HTL" has been selected).
Or, the I-DE is now in "Submenu 5C". (If "TTL" has been selected).
Push and hold the button for less than one second to change the selection (submenu); the LED
pattern (see above) will change.
Push and hold the button for two seconds, then release. After 2 seconds, this LED pattern will be
displayed.
The selection has now been saved. The A/B/Z signals will now be controlled in the required manner.
The I-DE is in "Main menu 5"
NOTE: Improper use of this function may cause damage to
external equipment
De Gier B.V., Westlandseweg 9, 2291 PG WATERINGEN, THE NETHERLANDS,
+31 174 292089, sales@degierdrivesystems.com, www.degierdrivesystems.com
Versie 1 – 07/01/2021
17