Grandstream Networks GWN7602 User Manual page 25

RADIUS NAS ID
Client Time Policy
Use MAC Filtering
Enable Dynamic VLAN
Client Isolation
Minimum Access Rate Limit
Gateway MAC Address
RSSI Enabled
Minimum RSSI (dBm)
Enter the RADIUS NAS ID.
This field is available only when "WPA Key Mode" is set to "802.1x".
Select a time policy to be applied to all clients connected to this SSID.
Choose Blacklist/Whitelist
excluded/included from connecting to the zone's Wi-Fi.
Default is Disabled.
When enabled, clients will be assigned IP address from corresponding
VLAN configured on the RADIUS user profile.
This field is available only when "WPA Key Mode" is set to "802.1x".
Client isolation feature blocks any TCP/IP connection between connected
clients to GWN76XX's Wi-Fi access point. Client isolation can be helpful
to increase security for Guest networks/Public Wi-Fi.
Three modes are available:
• Radio Mode: Wireless clients can access to the internet services,
GWN7xxx router and the access points GWN76XX but they cannot
communicate with each other.
• Internet Mode: Wireless clients will be allowed to access only the
internet services and they cannot access any of the management
services, either on the router nor the access points GWN76XX.
Gateway MAC Mode: Wireless clients can only communicate with the
gateway, the communication between clients is blocked and they cannot
access any of the management services on the GWN76XX access points.
• Specify whether to limit the minimum access rate for clients. When
enabled, it will help to eliminate the legacy connection which slow the
total performance of the Wi-Fi network. Range from 1 to 54 Mbps.
This field is required when using Client Isolation, so users will not lose
access to the Network (usually Internet). Type in the default LAN
Gateway's MAC address (router's MAC address for instance) in
hexadecimal separated by ":".
Example: 00:0B:82:8B:4D:D8
Check to enable RSSI function, this will lead the AP to disconnect users
below the configured threshold in Minimum RSSI (dBm).
Enter the minimum RSSI value in dBm. If the signal value is lower than the
configured minimum value, the client will be disconnected.
The input range is from "-94" or "-1".
GWN7602 User Manual
Version 1.0.15.20
to specify MAC addresses to be
P a g e | 25