Stationary Suspension; Suspension With Suspension Eye - Liftket B13 Operating Instructions Manual

For the assembly of the hook block please tighten the connection screws using the following torque values:
Hook block for chain 16×45
Hook block for chain 17.3×48
Table No. 2: Torques values for screw connections
During maintenance check the condition of the hook (for wear and centre punch spacing).
Also check the condition of the chain sprocket, of the safety latch and of the hook nut safe-
guard.
CAUTION
If required, clean and grease the axial bearing.
The hook nut of the load hook of the hook block is secured by a spring-pin inserted at a
right angle to the shaft.
4.1.3

Stationary suspension

4.1.3.1 Suspension with suspension eye

Do not use other bolts than the original suspensions bolts. In particular, do not use
CAUTION
screws to connect the electric chain hoist to its suspension elements.
Use the two bolts to fasten the provided suspension eye to the boreholes on the case of
NOTE the hoist configured for this purpose. Place the washer discs onto the bolts and secure
the bolts with the self-locking nuts.
Suspension eye
with marking
Self-locking nut
Washer disc
Diagram No 6: Suspension with suspension eye
12
Max. load capacity [kg]
12500
15000
Screws Quantity Tightening torque [Nm]
M12×50 DIN 912-8.8 4
M12×50 DIN 912-8.8 4
50
50
Suspension borehole
Bolt