Setting Failover Pairs - Adaptec ANA-6901 User Manual

3
Select the appropriate connection type for your network.
Autodetect (default) is the recommended choice. For an
explanation of possible options see Connection Types on
page A-2.
Note:
Duralink Failover.
Duralink Failover Setup V2.1
Use arrow keys to move, <Enter> to Select, <ESC> to go back to the previous menu.
©
Copyright 1998, Adaptec Inc.
You can set configuration parameters but leave the settings
Disabled for use at a later time by pressing Tab while the port
is selected.
4
Press Esc when you have completed port configuration.

Setting Failover Pairs

1
Select Set Failover Pairs from the Main Menu and press Enter.
Configure Ports
Set Failover Pairs
Configure Protocols
View Configuration
Install Software
Uninstall Software
The Thin (BNC) connector is not supported for
Connection Type
No. Port Name
Autodetect (default)
1 Empci1
Autodetect (default)
2 Empci2
Main Menu
Installing Duralink Drivers for NetWare
Netware Loadable Module
Type of Connection
Autodetect (default)
10 Mbps UTP/Half Duplex
10 Mbps UTP/Full Duplex
100 Mbps UTP/Half Duplex
100 Mbps UTP/Full Duplex
Thin
< F1> Help
< F10> Abort Setup
10-5