Host Adapter Layout; Default Settings - Adaptec AHA-1532P Installation Manual

2

Host Adapter Layout

This diagram and the following table show the major
AHA-1530P/1532P components.
U1
Label Description
DS1 Termination Indicator
J1 Floppy Drive Connector
J2 External LED Connector
J3 Internal SCSI Connector
J4 External SCSI Connector
1
AHA-1532 only.
P
3

Default Settings

AHA-1530P/1532P host adapters operate correctly
with their factory default settings in most PCs. The
default settings are as follows:
Parameter
Host Adapter SCSI ID
Interrupt Channel
Host Adapter Termination
Host Adapter BIOS
Initiate Synchronous Negotiation
Enable Disconnection
Port Address
SCSI Parity Checking
Extended BIOS Translation for Drives >1 GByte Disabled
Maximum Synchronous Transfer Rate
Support Removable Disks under BIOS
Send Start Unit Command
Floppy Drive Controller
1
AHA-1532P only
J1 J2
U7 S1
1
DS1 J3
U5
Label Description
S1 Switch Block
1
U1 Floppy Drive Controller
U5 AIC-3350 Plug and Play
Interface Chip
U6
U7 Host Adapter BIOS Chip
2
J4
U6
AIC-6360 SCSI Protocol Chip
Default Setting
7
IRQ 11
Automatic
Enabled at DC000h
Enabled
Enabled
340h-35Fh
Enabled
10 MBytes/sec.
Boot only
Disabled
Enabled
1