Plugging In Your Hub - Adaptec XHub4 Quick Start Manual

Plugging in Your Hub

Follow the picture below to connect your XHub unit to your computer
and to a power source.
Start by plugging in the power adapter. The green Power LED at the top
of the hub should light up when the power goes on.
Note:
Although the Power LED remains lit when the hub is
plugged in, the hub enters power-saver mode if there has been no
activity on the USB bus for 3 ms.
Step 3:
Plug USB cable into
USB port on computer.
Step 2:
Plug USB cable into
XHub USB Uplink port.
Hub Connections
6
Power LED
Step 1:
Plug power
adapter into
XHub Power port.
(to power source)