Table of Contents
Advertisement
Regulatory Compliance Statements
Federal Communications Commission Radio Frequency Interference Statement
WARNING: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy, and if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. However, if this equipment does cause
interference to radio or television equipment reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
I
Reorient or relocate the receiving antenna.
I
Increase the separation between equipment and receiver.
I
Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
I
Consult the dealer or an experienced radio/television technician for help.
I
Use a shielded and properly grounded I/O cable and power cable to ensure compliance
of this unit to the specified limits of the rules.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Adaptec, Inc.
FOR HOME OR OFFICE USE
XHub 4/XHub 4+/XHub 7+
Tested to Comply
With FCC Standards
26
Advertisement
Table of Contents
