Table of Contents
Advertisement
Note:
To stack your hubs without joining them (not pictured),
remove the face plates from all but the top hub, and then just pile
one hub on top of the other. Align the ports of each hub on one side
of the pile for easy access; the LEDs will then be visible on the
other side. Then follow Steps 3 and 4 below.
3
Connect a power adapter to each hub. (See
page
6.)
4
Connect your hubs to each other using a USB 2.0 cable, following the
connection suggestions in the diagram below.
Making the Most of Your Daisy-Chain
You can connect up to five XHub4s, or up to four XHub7s. The
maximum number of hubs on a daisy-chain will vary if you use a
combination of XHub4s and XHub7s. (This is a USB limitation.)
XHub4/XHub4 Plus
Use any USB port to connect to another XHub
XHub7 Plus
For maximum performance, use USB port 1, 3, or 5,
especially when stacking more than two hubs.
11
Plugging in Your Hub on
Advertisement
Table of Contents
