Troubleshooting - Jorvet ELECTROSURGE J0470M Operation Instructions Manual

.
1) Before starting, make sure all connections are correct.
R e m e m b e r : Hand piece into black socket; IND plate into red socket.
2) Too much sparking: Adjust power down by 2 positions.
3) Will not cut:
a) Is the power light on?
b) Foot pedal connected?
c) ACTIVE light on when foot pedal is depressed?
d) Electrode properly attached?
e) Indifferent Plate attached and properly placed?
Autoclaving Handpiece & Electrodes
The handpiece and electrodes should be thoroughly cleaned and
dried following a procedure. These can then be autoclaved in a
sterilization pouch at no more than 250° F for 10-15 minutes.
Trouble Shooting
8