Jorvet J-166M Directions For Use Manual
  1. Manuals
  2. Brands
  3. Jorvet Manuals
  4. Medical Equipment
  5. J-166M
  6. Directions for use manual

Jorvet J-166M Directions For Use Manual

Respiratory monitor
Hide thumbs
1
2
3
4
5
6

Advertisement

Table of Contents

J-166M
RESPIRATORY MONITOR
APNEA ALARM:
LIGHT SENSOR:
Sets time interval
Pass hand over to reset
for alarm to sound
LAPSE TIME
APNEA ALARM:
(in seconds)
30
40
20
50
10
60
Respiratory Monitor
Figure 1
Figure 2
Jorgensen Laboratories, Inc.
1450 N. Van Buren Ave.
Loveland, Colorado 80538
(970) 669-2500
TIME DISPLAY INDICATOR:
The seconds elapsed since
the last breath
BATTERY
BATTERY LEVEL
Green - Charging
Red - Low
VOLUME
VOLUME:
OFF
Monitor beeps
with every breath

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the J-166M and is the answer not in the manual?

Questions and answers

Related Manuals for Jorvet J-166M

Summary of Contents for Jorvet J-166M

  • Page 1 J-166M RESPIRATORY MONITOR APNEA ALARM: LIGHT SENSOR: TIME DISPLAY INDICATOR: Sets time interval Pass hand over to reset The seconds elapsed since for alarm to sound the last breath BATTERY BATTERY LEVEL Green - Charging LAPSE TIME APNEA ALARM: Red - Low...

  • Page 2: Directions For Use

    DIRECTIONS FOR USE Setup Respiratory Monitor in four easy steps. 1. Select and connect endo-tube to appropriate sensor adapter. 2. Connect sensor to the sensor adapter and sensor cable to the monitor. 3. Select apnea time for alarm. 4. Turn on monitor and set alarm volume. Setup Details 1a.
  • Page 3 The other end of the sensor cable has an 1/8 inch plug on it. Insert the plug into the socket marked “SENSOR” on the back of the monitor (See Figure 2). Be sure that it is pushed all the way into the socket. 3.

  • Page 4: Warranty & Service

    GETTING THE MOST FROM YOUR MONITOR WARRANTY SERVICE Parts will be warranted only if a copy of the original invoice Using the Breath Monitor With no breathing present, the LCD display will count seconds and defective parts are returned directly to : continuously.

  • Page 5: Warranty Statement

    REPLACEMENT PART CATALOG NUMBERS The monitor acts on changes in temperature. This occurs when the animal exhales warm air and inhales the cooler room air over the sensor. The greater the temperature difference, the smaller the J-166md#1A Sensor cable complete with connector. amount of air volume that is needed to trigger the monitor.

  • Page 6: Troubleshooting

    CARE AND FEEDING OF THIS BATTERY POWERED TROUBLESHOOTING INSTRUMENT The external power can remain connected to the monitor for extended periods of time without damage. The DC power socket on the monitor is shown in Figure 2. Insert the plug on the end of the Symptom.

Table of Contents