Advertisement
Step 5
Install ½-13 galvanized hex nut flat washer and split lock washer on the elevation adjust rod 6
Thread the nut approximately 20 inches up (as shown). Slide the adjustment rod through the slot
of the pole mount bracket opposite the tab being used for the azimuth adjust rod. Secure with
appropriate hardware as shown. Leave hardware loose for final adjustments.
6
Step 6
Attach antenna subassembly to the pole mounting bracket by locating the pipe onto the curved
recesses of the bracket. Attach the two assemblies together using (2) 3/8-16 U-bolts and
appropriate hardware as shown. Tighten hardware until snug. Do not fully tighten at this time.
FP100780-1_revG.docx
Page 8 of 11
Advertisement
