Advertisement
Antenna Assembly
Step 1
Attach antenna mounting pipe 2 to the Antenna ring with (4) 3/8-16 x 7/8 long hex head bolts,
split lock washers and flat washer.
2
Step 2
Attach azimuth bracket 3 to the pole with 3/8-16 U-bolt. Secure to pole with flat and split
lock washers and silicon bronze hex nuts. Before tightening, ensure the plate is facing the
approximate final direction of the antenna. Install 3/8-16 galvanized steel hex nut, lock and flat
washer onto the azimuth adjust rod 5 as shown in detail. Insert threaded rod into appropriate slot
in the azimuth adjust bracket. Add hardware to opposite side of threaded rod as shown and hand
tighten.
5
3
FP100780-1_revG.docx
Page 6 of 11
Advertisement
