Advertisement
PV panel Replacement-UrbanSpark
10. Pull out the broken PV panel at a distance of 20cm to the bottom pole carefully, and take out the plugs from
the pole. carefully disconnect the plugs, then remove the broken PV panel.
11. Clean glass cullet with brushes carefully.
And brush some soap-suds on the rubber mat for lubrication.
12 Insert the good PV panel to the pole carefully,
Do not bend the PV when inserting.
(You can use glass sucker for inserting easily.)
Note: You must test the PV panel's voltage
before assembling it to the pole. The voltage
value should be 10V~23V. You cannot install
the PV panel which value is less than 10V or
above 23V.
Broken PV panel
glass sucker
2
Rubber mat
Advertisement
