Philips UrbanSpark BDP301 Replacement

Pv panel replacement

Download this manual

PV panel Replacement-UrbanSpark

The battery presents a risk of electrical shock and a high short circuit current. The Philips mounting instructions must

be strictly followed, otherwise potential application, reliability or safety issues may arise. Only a qualified Philips service

representative who is knowledgeable in product and the required precautions is permitted to replacement . Keep

unauthorized person away from the product during the replacement. The deviation from standard instructions may

causes abnormal system operations or even dangerous situations.

Tools:

Spanner

Flat screwdriver

1. Open the

serve hatch

Pull

5.Lay down the pole carefully and put it on a soft pad

(like wood) to protect the PV panel during the whole

replacement process. Do not hit the panel with hard

objects such as stones, metal rods etc.

Note:

Whoever installs the system takes full responsibility

for safety during this process.

Allen wrench

Cross screwdriver

2. Disconnect all

cables and take

out the controller

Multi-meter

3. Take the

battery out

6. Remove the luminaire

7. Remove plastic caps

8. Remove four bolts

9. Remove the top part

Glass sucker(optional)

4. Remove the

fixing nuts

Page 1 PV panel Replacement-UrbanSpark The battery presents a risk of electrical shock and a high short circuit current. The Philips mounting instructions must be strictly followed, otherwise potential application, reliability or safety issues may arise. Only a qualified Philips service representative who is knowledgeable in product and the required precautions is permitted to replacement . Keep unauthorized person away from the product during the replacement.
Page 2 PV panel Replacement-UrbanSpark Broken PV panel 10. Pull out the broken PV panel at a distance of 20cm to the bottom pole carefully, and take out the plugs from the pole. carefully disconnect the plugs, then remove the broken PV panel. Rubber mat 11.
Page 3 PV panel Replacement-UrbanSpark 13. Push the good PV panel at a distance of 20cm to the bottom pole, and connect the plugs until you hear a “click” sound, then put the plugs into the pole through the hole. 14. Push the good PV panel to the end. 16.
Page 4 PV panel Replacement-UrbanSpark Note: Whoever installs the system takes full responsibility for safety during this process Pull 20. Affix the pole with M20 Nuts, spring washers and flat washers 19. Erect the Pole carefully 21. Put battery into the pole. 22.