After Use - Panasonic The Advanced RF Facial Device Operating Instructions Manual

After use

Cleanse the gel from the face.
• After cleansing off gel from the face, use your daily
skin care products to condition your skin.
• If you used a daily skin care product instead of the
conductive gel, you do not need to cleanse it off.
• After using the appliance, make sure to clean the main
body and frame.
• Check if the power is turned off.
1
1
Pinch the frame to remove.
• If gel is making it diffi cult to remove
the frame, wipe off excess gel and
then remove the frame.
2
2
Clean the head.
Use a tissue or similar to wipe off
gel or skin care product.
• Use a tissue, cotton swab, or similar
to remove any gel or skin care
product that has gotten into gaps.
18
EH-XR10_EU.indb 18
3
3
Attach the frame.
Align the four notches (b) with the
tabs () on the head and then
press the frame onto the head until
it clicks into place.
• Orient the frame so that the fl at
side (a) faces up.
4
4
Store the main body in the stand.
Notes
• The main body cannot be washed with water.
• If you are concerned that the main body is dirty, use a
cloth soaked with soapy water to wipe the dirt. Wring out
the cloth before wiping.
• Do not use alcohol, nail polish remover, or detergent
(ex. liquid hand soap), etc. to clean the appliance.
Doing so may cause failure, cracking or discoloration of
parts.
• Make sure to remove all excess gel or skin care product.
Failure to do so can cause hardening when this excess
material dries.

click


2019/03/14 19:45:10