“Energy Management" System (Operating Mode Selection) - Jeep COMPASS 4xe Manual

When the engine is started, the AUTO
mode is automatically selected (LED on
close to the AUTO message).
Turning the knob A fi g. 79 the LED close
to the AUTO message comes on solid.
The other LEDs switch on sequentially,
depending on the clicks set on the knob,
so that the driver can understand which is
the new required mode.
Once the desired mode has been reached
(LED on next to the message), the Selec-
Terrain™ system knob returns to the
starting position.
NOTE Activate the HDC system to control
the vehicle when driving down steep
paths. For more information, refer to what
is described in paragraph "HDC system"
in the "Safety" section).
"Energy Management" system (operating mode selection)
The Selec-Terrain™ system is able to interact with the different operating modes
("HYBRID" / "ELECTRIC" / "E-SAVE" of the car) according to the following table:
Operating Mode AUTO
HYBRID
X
E-SAVE
X
ELECTRIC
X
WARNING If you try to select an operating mode and the operating mode selection
system does not allow it, a dedicated message will appear on the instrument panel
display.
SPORT SNOW SAND/MUD
X X X
X
ROCK
X
97