Table of Contents
Advertisement
grasp the charging cable, remove the
protective cover (where provided) on
the connector (E) fig. 27 and plug it
into the charging port on the vehicle
until you hear the click indicating that
it has been locked;
charging starts automatically. If
necessary, the public charging
station must be enabled; follow the
manufacturer's instructions and
warnings when using the charging
station;
during the charging phase, the first
LED located next to the charging
socket on the vehicle flashes green
while the remaining LEDs are on with
steady light.
NOTE The charge procedure is
interrupted when opening the bonnet: a
dedicated message will be shown on the
instrument panel display. The charge
will be reactivated when the engine lid is
closed correctly.
WARNING In some countries the
"Mode 3" cable is not available.
WARNING Always connect the connector
fi rst to the socket on the public charging
station and then to the vehicle.
WARNING Unlocking the door locks
during the charging procedure will cause
it to stop. Charging resumes automatically
after about 60 seconds.
WARNING Before leaving the vehicle, it
is advisable to lock the doors by pressing
the button
on the key. If it is not
possible to lock the doors by pressing the
button
on the key, lock the doors by
pressing the button on the driver's side
door handle.
END OF CHARGING
PROCEDURE
The charging procedure ends when all
the LEDs (A) fi g. 31, located next to the
charging socket, will light up in green with
a steady light (during the charging phase
the fi rst LED will fl ash, while the other
LEDs will be on with a steady light).
31
J0B6035E
41
Advertisement
Table of Contents
