Table of Contents
Advertisement
16
34
CHARGING FROM DOMESTIC
POWER SUPPLY (AC) SOCKET
PROCEDURE
37) 38) 39) 40) 41)
WARNING Always connect the cable to the
charging socket of the domestic mains fi rst
and only then to the vehicle.
The vehicle's high-voltage battery is
charged by connecting the "Mode 2"
charging cable, supplied with the vehicle,
to an AC charging socket.
For the characteristics of the "Mode 2"
cable, refer to the "Power sources that
can be used - Mode 2 cable" chapter.
To charge, proceed as follows:
park the car safely (automatic
transmission lever in position "P" -
Park);
engage the electric park brake;
J0B6005E
switch off the engine;
take the kit located in the boot;
unroll the charge cable and connect it
to an AC charging socket, fig. 17.
NOTE From the moment the plug
is connected to the domestic mains
charging port, the 3 LEDs on the control
unit of the cable will fl ash for approx. 6
seconds (control unit switching on phase);
open the charging flap (A) fig. 18
located on the left side by pressing on
the area indicated by the arrow;
remove any dust that may have
accumulated on the charging
connector and charging socket;
17
J0B6000E
Advertisement
Table of Contents
