Testing Learned Remote Codes - Sony NHS-2000 Installation Manual

Appendix B: Programming Remote Control Codes
5. While the code ID number is displayed in the display window, press the corresponding button on the
remote control of the component while pointing it toward the learning IR window of the Multi-Room
Distribution Unit. When your entries are confirmed, "COMPLETED!" appears for a few seconds, then
the display window moves to the next remote code entry. If your entries are not confirmed, "LEARN
FAILED!" appears for a few seconds, then the failed code ID number appears.
TIPS
When you want to skip the code ID number, press the cursor.
When you want to re-enter the code ID, press the cursor.
NOTES
• When the remote code is successfully learned, a "*" will appear next to the remote code name.
• You can add up to 31 additional remote codes for each source component, and up to 10 for each
common component.
• You must complete step 5 within one minute after the remote code name is displayed in the display
window; otherwise, your entry will not be learned and "LEARN FAILED!" appears.
6. Repeat step 5 to enter other remote codes.
7. Press ENTER when you have finished. "SETTING NOW..." appears for a few seconds. Even if you
quit the LEARN mode in the midst of making
NOTES
• Even if you quit the LEARN mode in the midst of making the settings, the remote codes that have
already been learned will be stored.
• Some remote codes cannot be learned. In this case, "MEMORY FULL" appears, then the display
window returns to the previous remote code entry. The remote codes that have previously been learned
will be stored.

Testing Learned Remote Codes

You can check to see if the remote code of the source component has been successfully learned by the
Multi-Room Distribution Unit
1. Press SOURCE SELECT +/– to select the source component that you want to check.
2. Press MODE repeatedly until "<<CHECK>>" appears in the display window, then press ENTER. "SET
COMMAND" appears for a few seconds, then some of the learned remote codes appear in the display window.
3. Press the cursor or
4. Press ENTER. The selected remote command will be performed.
32
cursor repeatedly to select the remote code that you want to check (ex. play, stop).