Wake-up your e-Guard: 5 SEK When the button is pressed, SLEEP To activate the device you have to After that the display shows StArt for Cut excess with a saw and remove appears on the display. press the button 5 times within 5 a short time.
After the numbers “CLOSE” appears When the calibration was successful battey. Use a replacement battery e-Guard to check the display. low LED flashes for the second time on the display and the new hasp the display will show “donE”. If cali- from Unisto and the display shows “CAL”.
10 working days after custom clearance. firstly be returned to the nearest Unisto Site. Repairs may only be carried out at the Unisto site. Our aim is 5. Annex to repair or replace faulty units within 10 working days These terms and conditions supersede any prior upon receipt of the units in UCH.
The trailer number can only be set Go to the download with once! Initial operations: Cancel It’s important to make sure the e-Guard was once connected to the smartphone before use! Confirm last time seal was active latest No. seal closed...
Page 6
Type in a valid e-mail address to send the csv file.