Advertisement
TRAC-Guard
Installation user manual
Release the shackle (open padlock)
Open the Padlock with eKEY
1. Turn on the padlock's Bluetooth by pressing the center of the cylinder's bottom and simultaneously rotating the cylinder either
clockwise or counterclockwise.
Note : A LED at the bottom of the cylinder will flash green after the Bluetooth has been successfully activated.
2. Open the TRACcess eKEY app and select Open Device.
3. Enter PIN and Access Code if needed.
4. Select Begin.
5. Wait for success message to appear then rotate padlock cylinder clockwise until shackle releases.
Remove and reinstall the shackle
Remove the shackle
1. Use the shackle removal tool to rotate the hex screw
counterclockwise until removed
3. Open the padlock (see "Release the Shackle [Open Padlock]"
for details) and pull the shackle out of the padlock body when the
cylinder is in the release shackle position (maximum clockwise
rotation)
Note : If the shackle spring pops out, reinsert the spring into the shackle
hole nearest to the hex screw hole.
Reinstall the shackle
1. Insert the long side of the shackle into the shackle hole nearest
to the hex screw hole and the short side of the shackle into the
other shackle hole, then press the shackle all the way down to
lock into place.
3. Use the shackle removal tool to rotate the hex screw clockwise
until tight.
padlock
™
page 6
2. Tap or shake the padlock until the pin that was held in place by
the hex screw drops out.
Note : The first time a pin is removed may require rigorous tapping or
shaking.
2. Reinsert the pin with the pointed end toward the padlock body.
Advertisement
