Advertisement
TRAC-Guard
Installation user manual
Communication specifications
5. Tighten the cylinder cover
Align an insert both tips of the battery removal tool into two of the
holes located along the external knob ring, then apply enough
pressure with the battery removal tool to maintain insertions while
turning the cylinder cover clockwise until tight.
Install TRACcess eKEY app
1. Download and install the TRACcess eKEY app
from your device app store.
3. Open the TRACcess eKEY app and select Settings
5. Select Install
7. Turn on the padlock's Bluetooth by pressing the center
of the cylinder's bottom and simultaneously rotating the
cylinder either clockwise or counterclockwise
Note : A LED at the bottom
padlock
™
2. Open the TRACcess eKEY app and enter
4. Select Install Mode then Save
6. Select Are You Connecting to a TRAC-Guard Device then enter PIN
8. Select Begin, then after the success message appears,
9. Select Ignore or Assign Site ID to assign an optional site ID
of the cylinder will
flash green after the
Bluetooth has been
successfully activated.
page 5
6. Verify correct attachment
Make sure the cylinder cover is flush with the knob ring and do a
pull test to make sure the cylinder is attached
the authorization code.
select Done
Advertisement
