Advertisement
TRAC-Guard
Installation user manual
Communication specifications
Light sequence
green
red
Alternating
and
green
Flashing
Alternating
green
and
red
Alternating
green
and
red
Flashing
red
Flashing
red
Flashing
red
red
Flashing
Software
Software specifications
Compatible with Supra TRACcess system
Install or replace the battery
Note : The battery replacement tool (sold separately) is required to install or replace batteries.
1. Loosen the cylinder cover
Align and insert both tips of the battery removable tool into two of
the holes located along the external knob ring, then apply enough
pressure with the battery removable tool to maintain insertions
while turning the cylinder cover counterclockwise until loose
3. Insert the battery
Remove the existing battery, if needed, then insert the new battery
with the positive end pointing down (relative to lock body) and the
white strap goes under the battery
padlock
™
Flashes
Beeps
3
1
30
0
30
0
2
2
4
4
3
3
2
2
1
1
Compatible with IOS
page 4
State
Description
Normal
Lock shackle is released
Normal
Bluetooth is activated
Warning
Low battery
Warning
Very low battery
Error
Accelerometer sensor
Error
EEPROM error
Error
Motor module
Error
BLE module
version 7.0 or newer
Compatible with Android™ version 4.3
®
or newer
2. Detach the cylinder cover
The cylinder cover down (relative to lock body)
4. Reattach the cylinder cover
Align the outer alignment mark on the cylinder cover with the
alignment nodule of the cylinder, then push the cylinder up (relative
to lock body) into position
Advertisement
